Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 4 · Flush Supply Lines and Reassemble

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

If the issue persists after cleaning the aerator and cartridge, the final step is to check the water supply lines and shutoff valves. Place a bucket under the sink. Using two adjustable wrenches—one to hold the faucet's inlet shank steady and one to turn the nut—disconnect the hot water supply line from the faucet. Point the disconnected line into the bucket and slowly open the hot water shutoff valve. If you get a strong stream of water, the valve and line are clear. Close the valve and reconnect the line. Repeat the process for the cold water supply line. If the flow from either supply line is weak, the clog may be in the line itself or the shutoff valve. A faulty shutoff valve may need to be replaced, which is often a job for a professional plumber. After checking, reassemble all components in the reverse order of disassembly. Hand-tighten the sprayer head and supply line connections, then give a slight quarter-turn with a wrench. Turn the water supply back on slowly and check for leaks and improved pressure.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 4 · Flush Supply Lines and Reassemble

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

If the issue persists after cleaning the aerator and cartridge, the final step is to check the water supply lines and shutoff valves. Place a bucket under the sink. Using two adjustable wrenches—one to hold the faucet's inlet shank steady and one to turn the nut—disconnect the hot water supply line from the faucet. Point the disconnected line into the bucket and slowly open the hot water shutoff valve. If you get a strong stream of water, the valve and line are clear. Close the valve and reconnect the line. Repeat the process for the cold water supply line. If the flow from either supply line is weak, the clog may be in the line itself or the shutoff valve. A faulty shutoff valve may need to be replaced, which is often a job for a professional plumber. After checking, reassemble all components in the reverse order of disassembly. Hand-tighten the sprayer head and supply line connections, then give a slight quarter-turn with a wrench. Turn the water supply back on slowly and check for leaks and improved pressure.

Videos for this step

Flush and Test FaucetTest Installation for Leaks and FunctionalityTest the Repair

Tools and Materials

← Project

How to Fix Low Water Pressure in a Single Faucet

Step 4 of 4·15 min left

Shut Off Water and Remove Sprayer Head
5 mins2 itemsBeginner
Clean and Soak the Sprayer Head
60 mins4 itemsBeginner
Inspect and Clean the Faucet Cartridge
15 mins6 itemsAdvanced
4
Flush Supply Lines and Reassemble
15 mins4 itemsAdvanced
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.