Skip to main content

Cut Stringer Sections for Treads and Risers — Cut the Opening

Beginner8 hours

Part of project

How to Install an Alternating Tread Stair Kit · Step 2 of 7

Helpful?

In this video

Once marked, the cutouts for the treads and risers on both the outer and inner stringers are made. A circular saw (specifically a Makita model is shown) is used for the straight cuts, carefully following the marked lines. For the curved sections and tighter angles where a circular saw cannot reach, a jigsaw (also a Makita model shown) is used to complete the cuts. Safety precautions like wearing hearing protection and safety glasses are essential during this step. The precision of these cuts directly impacts the fit and structural integrity of the entire stair assembly.

17.5K views511
Transcript
Hide

stringer. Cutting the stringers is tedious, but it's also one of the most satisfying stages. By this point, the layout is proven. The uncertainty is gone. No second-guing, just execution. On a project like this, I'm reminded of restoration work I've done in the past. When you open the old walls, you can immediately tell who cared and who didn't. Most of this stair would disappear behind finishes, but the people finishing it next or opening it up during a remodel a 100 years from now will appreciate the extra work we put in and the role we play in shaping the final appearance.

Auto-generated transcript. May contain errors.