Skip to main content

Install Balusters

Beginner2 hours

Part of project

How to Measure Baluster Spacing and Handrail Height · Step 6 of 7

Helpful?

In this video

Install the balusters (vertical spindles) for the railing. Pre-drill a pilot hole into the angled end of a 36-inch baluster and partially drive a 2.5-inch screw into it. Position the baluster against the stringer, aligning it correctly, and drive the screw into the stringer. Ensure the spacing between balusters is no more than 4 inches to meet safety standards. To mark the position of the second baluster, use a speed square from the previous post. Place it against the installed baluster, draw a line 4 inches away, then use the diagonal to mark a line downwards. Repeat this process for all balusters until the railing is complete.

20.7K views343
Transcript
Hide

now for the balusters i'm going to use pre-drill hole again and then putting a two and a half inch screw into each of these turn it around and do the same on all of them i need six total for this staircase now using the speed square from my top post i'm going to come over four inches and make a mark there and then i can use my diagonal again to just draw that line down and then let's go up to the top i'm going to do the same thing where i use my speed square to come out four inches and then use that diagonal to draw the line down and that's going to be the location of the outside of the baluster so i want to just make sure it's down from the top by about a quarter inch or so and then i can just use a single screw to hold that in there now back at the bottom i want to just use my speed square to make sure that this is correct at the four inch mark and it is and then just get this piece screwed in and there we have it that's the first of the six balusters so i'm just going to continue that process until i have all of those done

Auto-generated transcript. May contain errors.