Skip to main content

Install Box Newel Post with Sure-Tight Fastening System — Attach Mounting Hardware (if applicable)

Beginner4 hours

Part of project

How to Install a New Newel Post · Step 3 of 6

Helpful?

In this video

Use a square to find and mark the exact center at the bottom of the new box newel post. Measure 5 inches up from the bottom and drill a 1 1/2-inch wide hole with a forstner bit, approximately 2 1/2 inches deep. Then, switch to a 3/8-inch drill bit and continue drilling through the rest of the post. Next, drill a horizontal hole on the side of the newel post at the correct height to meet the vertical hole. Start with a 3/8-inch drill bit, then widen it with a 5/8-inch bit. Use a level to ensure accuracy. Screw the sure-tight bolt into the floor, ensuring it's securely anchored. Then, place the newel post over the bolt, add a crescent-shaped washer, and tighten the nut with a wrench. This system provides a robust anchor for the newel post without needing to frame it into the subfloor.

391.0K views2.4K