Skip to main content

Install Carpet Runner — Install Stair Treads/Runners (Option 2)

Beginner3 mins

Part of project

How to Protect Stairs from Dog Nail Scratches · Step 5 of 5

Helpful?

In this video

If your stair treads hang over the riser, you will use the 'wrap' installation method. If the treads do not hang over the riser, you can use the 'waterfall' method, which is similar but without tucking the runner under the nose. You can choose to start installing the runner from either the bottom or the top of the staircase, depending on the room's size and space. If necessary, use a crowbar to carefully remove any shoe molding at the base of the stairs. Cut a strip of double-sided tape that is slightly shorter than the width of the rug. Press this tape along the top edge of the riser of the first tread, just under the nose or the base of the riser. Next, line up the edge of the carpet runner with the tape and press firmly to adhere it. Use a staple gun to staple the runner to the bottom of the riser. Then, use a bolster chisel to create a hard crease under the nose of the stair. Staple the center of the rug to the underside of the nose, and then staple every three inches on either side. Smooth the rug against the riser and use a carpet stretcher to create a tight crease at the next tread. Staple the center of the rug to the bottom of that riser, then every three inches on either side. Continue stapling the base of the riser and underneath the nose of each stair until you reach the end of the runner.

181.7K views843