Skip to main content

Install Balusters — Install Balusters (Spindles)

Beginner8 hours

Part of project

How to Install a Deck Stair Railing · Step 4 of 6

Helpful?

In this video

Prepare several narrower wooden balusters. To prevent wood splitting, pre-drill pilot holes at both the top and bottom ends of each baluster using a drill. Position these balusters vertically between the horizontal rails, ensuring consistent spacing (e.g., 4.25 inches as mentioned by the creator, or per local code). Secure each baluster in place with exterior screws using an impact driver, driving two screws at the top and two at the bottom. Before final fastening, use a spirit level to verify each baluster is plumb.

3.4K views102
Transcript
Hide

i figure i'll need four of these balusters to go up here in between and to make sure it doesn't crack i've got a drill bit here so i'm just going to be pre-drilling the wood on both the upper and lower portions go ahead and start the screws in here to make it easier okay and now i'm going to set this up here and i've marked out where i want it on this lower portion so i can go ahead and get that screwed in and before i screw in the top one i want to just take my level here the sun's out so it's kind of hard for me to show you this angle from down below but uh this four foot board sticks out to this point and i'm just going to bring a board down here and i'll have to build this out a little bit by sticking a couple of two by fours here as you can see we've got about two inches here to interfere with that so i'm going to build out two boards and then cut the board up here to match this which should be a little over three foot here so let's see there to yeah i think 40 inches is where we're gonna need to be right there and the railing is up on this side

Auto-generated transcript. May contain errors.