Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 5 · Reassemble and Test for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Reinstall the handle, escutcheon, and shower head. Slowly turn the water supply back on, carefully checking all connections for leaks. If leaks persist, tighten connections or reapply Teflon tape as needed. Run the shower for several minutes to fully test.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 5 · Reassemble and Test for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Reinstall the handle, escutcheon, and shower head. Slowly turn the water supply back on, carefully checking all connections for leaks. If leaks persist, tighten connections or reapply Teflon tape as needed. Run the shower for several minutes to fully test.

Videos for this step

Test for LeaksTest and TroubleshootTest the Repair

← Project

Shower Faucet Valve Replacement: A Step-by-Step DIY Guide

Step 5 of 5·30 min left

Turn Off the Water Supply
5 minsBeginner
Remove the Shower Handle and Escutcheon
15 mins1 itemsIntermediate
Remove the Old Shower Valve
30 mins1 itemsAdvanced
Install the New Shower Valve
30 mins1 itemsAdvanced
5
Reassemble and Test for Leaks
30 minsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.