Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 2 · Step 2: Measure Your Tread Depth (The Run)

For each individual step, place the end of your tape measure firmly against the vertical riser at the back. Extend the tape straight across the tread, going over the front edge or 'nosing'. It is crucial that your tape measure stays flat and level for an accurate reading. A critical safety note: Never measure over existing carpet or old flooring, as this will skew your numbers and prevent your new treads from fitting securely.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 2 · Step 2: Measure Your Tread Depth (The Run)

For each individual step, place the end of your tape measure firmly against the vertical riser at the back. Extend the tape straight across the tread, going over the front edge or 'nosing'. It is crucial that your tape measure stays flat and level for an accurate reading. A critical safety note: Never measure over existing carpet or old flooring, as this will skew your numbers and prevent your new treads from fitting securely.

Videos for this step

Measure and Mark TreadsMeasure Treads and Mark LaminateMeasure and Mark Tread and Nosing

← Project

measurements

Step 2 of 4·16 min left

Step 1: Count Your Steps & Gather Your Tools
5 minutes
2
Step 2: Measure Your Tread Depth (The Run)
3 minutes
3
Step 3: Determine Your Tread Width
3 minutes
4
Step 4: Record, Label, and Double-Check
10 minutes
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.