Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 10 · Turn on Water and Check for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Before turning the water on, double-check that all connections are snug. Unscrew the aerator from the tip of the new faucet spout to prevent any debris from clogging it. Place a rag over the spout opening. Slowly turn the water back on at the shutoff valves. Let the water run for a minute to flush any sediment out of the lines. While the water is running, use a flashlight to meticulously inspect every connection point for leaks: at the shutoff valves, at the faucet tailpieces, and around the drain assembly. If you find a leak, turn the water off and gently tighten the connection another 1/8 to 1/4 turn. Once you are certain there are no leaks, turn the water off, screw the aerator back on, and your project is complete.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 10 · Turn on Water and Check for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Before turning the water on, double-check that all connections are snug. Unscrew the aerator from the tip of the new faucet spout to prevent any debris from clogging it. Place a rag over the spout opening. Slowly turn the water back on at the shutoff valves. Let the water run for a minute to flush any sediment out of the lines. While the water is running, use a flashlight to meticulously inspect every connection point for leaks: at the shutoff valves, at the faucet tailpieces, and around the drain assembly. If you find a leak, turn the water off and gently tighten the connection another 1/8 to 1/4 turn. Once you are certain there are no leaks, turn the water off, screw the aerator back on, and your project is complete.

Videos for this step

Test for Leaks and FunctionalityTesting the InstallationReassemble and Test Faucet

Tools and Materials

← Project

How to Replace a Two-Handle Bathroom Faucet

Step 10 of 10·15 min left

Preparation and Water Shutoff
10 mins2 itemsBeginner
Disconnect Water Supply Lines
15 mins4 itemsIntermediate
Disconnect Pop-Up Drain Linkage
10 mins3 itemsIntermediate
Remove the Old Faucet
20 mins3 items
Remove the Old Drain Assembly
15 mins2 itemsIntermediate
Clean Sink Surface
10 mins3 itemsBeginner
Install New Faucet
20 mins2 itemsAdvanced
Install New Drain Assembly
20 mins4 itemsIntermediate
Connect New Water Supply Lines
15 mins2 itemsIntermediate
10
Turn on Water and Check for Leaks
15 mins3 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.