Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 9 · Test for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

The final and most important step is to test for leaks. Use a drain plug or stuff a rag tightly into the drain opening to block it. Fill the shower base with 1-2 inches of water, enough to completely submerge the new drain flange. Use a marker or a piece of tape to mark the water level. Let it sit for at least 30 minutes, then check if the water level has dropped. If it hasn't, you have a good seal on top. Now, remove the plug and let all the water drain. If you have any way to check the area below the shower (even a small inspection mirror through a vent), do so now to check for any drips from the gasket seal below. Wait 24 hours before using the shower to allow any silicone or putty to fully cure.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 9 · Test for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

The final and most important step is to test for leaks. Use a drain plug or stuff a rag tightly into the drain opening to block it. Fill the shower base with 1-2 inches of water, enough to completely submerge the new drain flange. Use a marker or a piece of tape to mark the water level. Let it sit for at least 30 minutes, then check if the water level has dropped. If it hasn't, you have a good seal on top. Now, remove the plug and let all the water drain. If you have any way to check the area below the shower (even a small inspection mirror through a vent), do so now to check for any drips from the gasket seal below. Wait 24 hours before using the shower to allow any silicone or putty to fully cure.

Videos for this step

Test and SealClean Surface and Apply SiliconeDisconnect from Drain Pipe

Tools and Materials

← Project

How to Replace a Shower Drain in an Existing Shower Base

Step 9 of 9·40 min left

Preparation and Safety
15 mins3 itemsBeginner
Remove the Old Drain Strainer
10 mins2 itemsBeginner
Unscrew and Remove the Old Drain Body
30 mins2 items
Clean the Drain Opening and Pipe
20 mins3 itemsIntermediate
Prepare and Dry-Fit the New Drain
15 mins5 itemsIntermediate
Apply Plumber's Putty and Set the Drain Body
10 mins2 itemsIntermediate
Secure the Drain and Gasket
20 mins4 itemsAdvanced
Clean Up and Install Strainer
5 mins3 itemsBeginner
9
Test for Leaks
40 mins5 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.