Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 5 · Locate and Mark Water Supply Lines

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

The water supply lines (or stub-outs) feed the hot and cold water to the faucet. Standard practice places these lines several inches above the drain line to prevent interference. A typical height is 21 to 22 inches from the finished floor. For horizontal placement, they are typically spread apart to allow room for the shut-off valves and supply hoses. A common configuration is to place the cold water line 4 inches to the right of the sink drain centerline, and the hot water line 4 inches to the left of the centerline (creating an 8-inch spread between them). Hot is always on the left, and cold is on the right. Mark these two locations on the wall. Again, review the vanity spec sheet to ensure these locations do not conflict with drawers, shelving, or the sink basin itself.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 5 · Locate and Mark Water Supply Lines

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

The water supply lines (or stub-outs) feed the hot and cold water to the faucet. Standard practice places these lines several inches above the drain line to prevent interference. A typical height is 21 to 22 inches from the finished floor. For horizontal placement, they are typically spread apart to allow room for the shut-off valves and supply hoses. A common configuration is to place the cold water line 4 inches to the right of the sink drain centerline, and the hot water line 4 inches to the left of the centerline (creating an 8-inch spread between them). Hot is always on the left, and cold is on the right. Mark these two locations on the wall. Again, review the vanity spec sheet to ensure these locations do not conflict with drawers, shelving, or the sink basin itself.

Videos for this step

Positioning the Water SupplyInstall Sensor Valve Under SinkRun PEX Water Supply Lines

Tools and Materials

← Project

How to Measure Bathroom Plumbing Rough-In Dimensions for a New Vanity

Step 5 of 6·15 min left

Gather Information and Tools
5 mins4 itemsBeginner
Establish Vanity Centerline
5 mins3 itemsBeginner
Mark Vanity Height and Width
5 mins4 itemsIntermediate
Locate and Mark the Drain Line
10 mins3 itemsAdvanced
5
Locate and Mark Water Supply Lines
10 mins3 itemsAdvanced
6
Verify All Measurements
5 mins2 itemsBeginner
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.