Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 4 · Clean, Flux, and Dry-Fit Components

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Thoroughly clean the outside of the two cut pipe ends and the inside of all three openings of the copper T-fitting using emery cloth. The copper should be shiny. Also, clean one end of your 12-inch pipe section and the inside of the copper cap. Once clean, use a flux brush to apply a thin, even layer of soldering flux to all cleaned surfaces. Assemble the pieces for a 'dry fit': slide the T-fitting onto the pipe ends and insert the 12-inch air chamber pipe into the top of the 'T'. Place the cap on the air chamber pipe. Ensure everything fits snugly and is aligned correctly.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 4 · Clean, Flux, and Dry-Fit Components

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Thoroughly clean the outside of the two cut pipe ends and the inside of all three openings of the copper T-fitting using emery cloth. The copper should be shiny. Also, clean one end of your 12-inch pipe section and the inside of the copper cap. Once clean, use a flux brush to apply a thin, even layer of soldering flux to all cleaned surfaces. Assemble the pieces for a 'dry fit': slide the T-fitting onto the pipe ends and insert the 12-inch air chamber pipe into the top of the 'T'. Place the cap on the air chamber pipe. Ensure everything fits snugly and is aligned correctly.

Videos for this step

Prepare New Pipes and FittingsPrepare the Copper PipeClean and Flux Pipes

Tools and Materials

← Project

How to Install an Air Chamber to Prevent Water Hammer

Step 4 of 6·50 min left

Diagnose and Locate the Problem Area
15 minsBeginner
Shut Off Water Supply and Drain Pipes
15 mins2 itemsIntermediate
Cut the Copper Pipe
10 mins5 itemsAdvanced
4
Clean, Flux, and Dry-Fit Components
15 mins6 itemsIntermediate
5
Solder the Joints
20 mins7 items
6
Restore Water and Check for Leaks
15 mins1 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.