Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 4 · Connect Water Supply Lines and Drain

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

Now, make the final plumbing connections. First, attach the new flexible water supply lines to the threaded tailpieces on the bottom of the faucet. Hand-tighten these connections, then give them a quarter-turn with an adjustable wrench. Connect the other ends of the supply lines to the corresponding hot and cold shutoff valves. Again, hand-tighten and then give a quarter-turn with the wrench. Next, assemble the P-trap. Connect the tailpiece coming down from the sink drain to the P-trap U-bend, and the trap arm to the drain pipe in the wall. You may need to cut the PVC tailpiece or trap arm to the correct length with a hacksaw or tubing cutter. Ensure all slip nuts have their tapered plastic washers oriented correctly (taper facing the direction of the seal) before tightening. Hand-tighten all the P-trap slip nuts; they do not need a wrench.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 4 · Connect Water Supply Lines and Drain

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

Now, make the final plumbing connections. First, attach the new flexible water supply lines to the threaded tailpieces on the bottom of the faucet. Hand-tighten these connections, then give them a quarter-turn with an adjustable wrench. Connect the other ends of the supply lines to the corresponding hot and cold shutoff valves. Again, hand-tighten and then give a quarter-turn with the wrench. Next, assemble the P-trap. Connect the tailpiece coming down from the sink drain to the P-trap U-bend, and the trap arm to the drain pipe in the wall. You may need to cut the PVC tailpiece or trap arm to the correct length with a hacksaw or tubing cutter. Ensure all slip nuts have their tapered plastic washers oriented correctly (taper facing the direction of the seal) before tightening. Hand-tighten all the P-trap slip nuts; they do not need a wrench.

Videos for this step

Assemble the P-TrapConnect Drain PlumbingInstall New P-Trap

Tools and Materials

← Project

How to Install a Bathroom Sink and Faucet from Start to Finish

Step 4 of 5·45 min left

Preparation and Old Sink Removal
45 mins7 itemsAdvanced
Install Faucet and Drain on New Sink
45 mins6 itemsAdvanced
Set the New Sink in the Countertop
20 mins5 itemsIntermediate
4
Connect Water Supply Lines and Drain
30 mins3 itemsAdvanced
5
Final Checks and Testing
15 mins2 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.