Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 3 · Flush Sediment from Tank

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

With the hose connected, turn OFF the cold water supply valve (the one you checked in step 1). Next, go to a sink inside the house (the kitchen sink is often a good choice) and open the hot water tap fully. This is a crucial step that allows air to enter the plumbing, breaking the vacuum and allowing the tank to drain. Return to the water heater and open the drain valve using a screwdriver or pliers. Water, which will be hot and possibly discolored with sediment, will begin to flow out. To aggressively dislodge stubborn sediment, wait for the flow to slow, then close the drain valve, turn the cold water supply ON for 10-15 seconds to stir up minerals at the bottom, then turn it OFF and re-open the drain valve. Repeat this 'pressure flushing' process 3-4 times until the water draining from the hose runs clear.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 3 · Flush Sediment from Tank

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

With the hose connected, turn OFF the cold water supply valve (the one you checked in step 1). Next, go to a sink inside the house (the kitchen sink is often a good choice) and open the hot water tap fully. This is a crucial step that allows air to enter the plumbing, breaking the vacuum and allowing the tank to drain. Return to the water heater and open the drain valve using a screwdriver or pliers. Water, which will be hot and possibly discolored with sediment, will begin to flow out. To aggressively dislodge stubborn sediment, wait for the flow to slow, then close the drain valve, turn the cold water supply ON for 10-15 seconds to stir up minerals at the bottom, then turn it OFF and re-open the drain valve. Repeat this 'pressure flushing' process 3-4 times until the water draining from the hose runs clear.

Videos for this step

Connect Hose and Drain the TankPrepare and Drain the Water HeaterPartially Drain the Tank

Tools and Materials

← Project

How to Fix Low Water Pressure in Only the Hot Water Lines

Step 3 of 5·1.1 hr left

Safety & Initial Valve Check
10 mins2 itemsBeginner
Connect Drain Hose
10 mins4 itemsBeginner
3
Flush Sediment from Tank
45 mins7 itemsAdvanced
4
Refill and Purge
15 mins1 itemsIntermediate
5
Restore Power and Final Test
5 minsBeginner
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.