Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 6 · Reassemble Faucet and Test for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Reassemble the faucet in the reverse order of disassembly. First, thread the packing nut back onto the faucet body by hand. Then, use your adjustable wrench to tighten it, but only until it's snug. Do not overtighten. Next, place the handle back onto the end of the stem, aligning it correctly with the grooves. Insert the handle screw and tighten it with your screwdriver. Close the outdoor faucet by turning the handle clockwise until it stops. Now, go back inside and slowly turn the water shut-off valve back on. Listen for any sounds of running water and check the valve itself for any leaks. Finally, go back outside and inspect the faucet spout and handle area for any drips. If there's a slight weep from around the packing nut, give it a very small (1/8th turn) tightening with the wrench until the weeping stops.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 6 · Reassemble Faucet and Test for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Reassemble the faucet in the reverse order of disassembly. First, thread the packing nut back onto the faucet body by hand. Then, use your adjustable wrench to tighten it, but only until it's snug. Do not overtighten. Next, place the handle back onto the end of the stem, aligning it correctly with the grooves. Insert the handle screw and tighten it with your screwdriver. Close the outdoor faucet by turning the handle clockwise until it stops. Now, go back inside and slowly turn the water shut-off valve back on. Listen for any sounds of running water and check the valve itself for any leaks. Finally, go back outside and inspect the faucet spout and handle area for any drips. If there's a slight weep from around the packing nut, give it a very small (1/8th turn) tightening with the wrench until the weeping stops.

Videos for this step

Reassemble the FaucetTighten the Packing NutReassemble the Faucet

Tools and Materials

← Project

How to Fix a Dripping Frost-Free Outdoor Faucet

Step 6 of 6·15 min left

Shut Off Water Supply and Drain the Faucet
10 minsBeginner
Disassemble the Faucet Handle and Packing Nut
15 mins4 itemsIntermediate
Remove the Faucet Stem Assembly
5 minsIntermediate
Inspect and Replace Worn Parts
20 mins4 itemsAdvanced
Reinstall the Faucet Stem
5 mins2 itemsBeginner
6
Reassemble Faucet and Test for Leaks
15 mins2 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.