Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 6 · Verify Crimp with Go/No-Go Gauge

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

This is the final and most important quality control step. Take your go/no-go gauge. First, attempt to slide the 'Go' slot over the compressed ring. It should fit snugly. Next, attempt to slide the 'No-Go' slot over the ring. It should NOT fit. If the 'Go' slot does not fit, the ring is under-crimped. If the 'No-Go' slot fits, the ring is over-crimped. In either case of failure, the connection is bad and must be redone. Use a special ring-cutting tool or carefully cut the ring off with a rotary tool, remove the fitting, and start over from Step 2 with a new piece of tubing, a new ring, and a new fitting.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 6 · Verify Crimp with Go/No-Go Gauge

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

This is the final and most important quality control step. Take your go/no-go gauge. First, attempt to slide the 'Go' slot over the compressed ring. It should fit snugly. Next, attempt to slide the 'No-Go' slot over the ring. It should NOT fit. If the 'Go' slot does not fit, the ring is under-crimped. If the 'No-Go' slot fits, the ring is over-crimped. In either case of failure, the connection is bad and must be redone. Use a special ring-cutting tool or carefully cut the ring off with a rotary tool, remove the fitting, and start over from Step 2 with a new piece of tubing, a new ring, and a new fitting.

Videos for this step

Check CrimpPrepare PEX PipeNo-Go Check for Over-Crimp

Tools and Materials

← Project

How to Cut and Crimp PEX Tubing Like a Pro

Step 6 of 6·almost done

Gather Tools and Materials
2 mins7 itemsBeginner
Cut the Tubing
1 min4 itemsIntermediate
Slide on Crimp Ring
30 mins2 itemsBeginner
Insert Fitting into Tubing
30 mins2 itemsBeginner
Crimp the Ring
1 min4 itemsAdvanced
6
Verify Crimp with Go/No-Go Gauge
1 min4 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.