Skip to main content

Install All Shelves — Cut and Install Shelves

Beginner3 mins

Part of project

How to Turn an Under-Stair Closet into a Pantry · Step 5 of 7

Helpful?

In this video

After cutting, test fitting, and notching all shelves as needed, it's time for final installation. For added strength and to prevent warping, glue the shelves to the ledger boards using a strong construction adhesive like Loctite PL3X. Apply a bead of adhesive along the top edge of the ledger boards and the vertical supports. Carefully slide each shelf into place, ensuring a snug fit against the wall and supports. Once positioned, use a drill to secure the shelves to the ledger boards and vertical supports with screws, pre-drilling and countersinking as necessary.

2.4K views18
Transcript
Hide

All right. So, let's see if it actually works or if I need to make an adjustment. All right. So, what I did, guys, is I just made a mark 48 and 48. So that way it's a little bit easier to kind of line this up even though I have the back ones too. That way it's a double check. All right. And you're going to see I have a little bit of a gap here. It was a little different than that one over there. That one was tight. I cut this as a template or actually use that as a template and cut this. But we have a block that's going to go here which will hide that. Okay. We got that. It's good. Right about there is pretty good. That looks pretty good right there, guys. So, now we are going to put our screws in. Now, when I go to cut the shelves, I'll probably start at the top, work my way down because this is locked in. I'll use my speed square again, make sure that it's square, and then the rest should just fall into place. We're on to the stage where we are going to cut the little support bracket pieces that are going to go on the new dividers that we just built. Now, if you're a DIYer and you haven't done this before, it's going to take you a long time to cut all of these supports. So, there is an easier way. Take a spare block and a clamp and clamp it to your fence to the exact measurement of the cut. Just like that. Now, what I can do is I can just keep cutting just like this over and over until I get what I need. And everything is going to be exactly the same and extremely quick. And we're going to go ahead and start with the blocks. Line them up with this back one and at least get the back screw in like this. That way it'll be easier to put the shelves on and then just adjust them just like that. We'll leave this one loose in case I need to move it up or down just a little to line them up.

Auto-generated transcript. May contain errors.