
How to Install Carpet Treads on Winder Steps
About This Project
A high-level outline for installing carpet treads on winder steps, focusing on preparation, measurement, cutting, and attachment.
Tools & Materials

Putty knife

Shop Vacuum

Scrub Brush
Measuring Tape

Pencil

Empire 8 in. x 12 in. Steel Carpenter Square 100

Putty knife
Spreads putty with its flat blade.

Shop Vacuum
Cleans workshop mess efficiently.

Scrub Brush
Tackles tough stains with stiff bristles.
Measuring Tape
For accurate measurements of plywood and components, ensuring proper assembly.

Pencil
Marks and draws with ease.

Empire 8 in. x 12 in. Steel Carpenter Square 100
The Empire 8 in. x 12 in. Steel Carpenter Square is ideal for lying out and marking patterns in framing, roofing and stairway work. A durable protective epoxy finish helps prevent rusting. Features deep
Steps
Inspect and Prepare Existing Treads
30 minutesBefore installing carpet treads, carefully inspect each existing stair tread for any signs of damage such as cracks, rot, or loose pieces. Also, check for any unevenness or bumps that could affect the fit and adhesion of the new treads. Clean the surface of each tread thoroughly, removing all dust, dirt, debris, and any old adhesive residue. A clean, smooth surface is crucial for the carpet treads to adhere properly and last.
Watch: Clean the StairsMeasure and Mark for Winder Tread Cuts
60 minutesWinder stairs have angled treads that meet at a corner, requiring custom cuts for carpet treads. For each winder tread, measure its depth from the nosing to the back of the tread at the narrowest point and the widest point. Then, measure the width of the tread at the nosing and at the back. Carefully mark these dimensions onto the carpet tread material, paying close attention to the angle of the winder. A common method is to trace the shape of the existing tread onto the back of the carpet tread material, ensuring the pattern or pile direction is consistent across all treads.
Watch: Measure Winder Steps DepthCut Carpet Treads for Winder Stairs
45 minutesUsing the markings made in the previous step, carefully cut the carpet tread material. For straight edges, a sharp utility knife or a heavy-duty scissor is typically used. For the angled cuts on winder treads, a sharp utility knife is essential. Make multiple passes with the knife rather than trying to cut through in one go, especially for thicker carpet or backing. Ensure the cuts are clean and follow the marked lines precisely to achieve a perfect fit. If a template was created, use it as a guide for cutting the actual tread material.
Watch: Cut Carpet PiecesAttach Carpet Treads to Winder Stairs
60 minutesOnce the carpet treads are cut and the existing treads are clean, it's time for attachment. Most carpet treads come with an adhesive backing or are designed to be attached with a strong, double-sided carpet tape or adhesive. Peel off the protective backing from the adhesive. Carefully align the carpet tread with the existing stair tread, starting from the back or the tightest angle of the winder. Press down firmly, working from the center outwards, to ensure complete contact and a secure bond. Pay special attention to the edges and corners of the winder treads to eliminate any lifting or gaps. For enhanced security, some carpet treads can be further secured with small staples or brads, though this is less common with pre-made treads and may damage the underlying tread.
Watch: Install Carpet Treads with Adhesive





